The FUNDAMIX® is a universal device for mixing liquids in open or closed vessels, under vacuum or pressure, even in sterile conditions.
It was invented and patented in the late 1960s by Dr. Hans Mueller and subsequently manufactured by Chemap AG under his ownership. The vibratory mixer product line was sold to Graber & Pfenningger GmbH in 1983 and was reacquired by DrM, Dr. Mueller AG in 2012 and renamed FUNDAMIX®.
The electro-magnetic drive operates at 50 to 60 Hz and transmits the vibration via the mixing device or mixing plate attached to a special clamp coupling into the medium.
The amplitude resp. mixing effect is controlled by an electronic system and can be adjusted from 0 to 4 mm. The flow direction can be adapted to suit the medium and required mixing effect. The mixing direction depends on the orientation of the conical holes.
Standard mixers are in 316 stainless steel, but can be manufactured from a wide range of materials including Hastelloy, Titanium and various plastics.
FUNDAMIX® can operate continuously without overheating or amplitude variations.
How it works
Principle of Operation
The mixing effect is produced by vibration transmitted to a perforated stirrer plate equipped with conical bores. Due to the Bernoulli effect, this vibration causes the liquid to be pumped upward or downward through the cones.
Stirrer Plate Type A
The conical bores point upward and the liquid jet flows vertically up to the surface. It is used in several applications such as agitation, emulsification and homogenization, with varying liquid levels. If two liquid phases with different specific weights have to be emulsified, the stirrer plate must always be immersed into the liquid phase with the higher specific weight. The optional distance from the stirrer plate to the bottom of the vessel varies between 20 and 150mm.
Stirrer Plate Type B
The conical bores point downward. Therefore the liquid jet flows towards the vessel bottom. This type of stirrer plate is used for suspending solids in liquids and when no air or gas from the liquid surface should enter into the liquid.
Stirrer Plate Type B With Gas Dispersion
The stirrer shaft is hollow and allows gas to get injected below the stirrer plate. Due to the liquid flow, an optimal gas dispersion effect is reached. This type of stirrer plate is used to saturate liquids with O2 or in any other gas/liquid reactions.